LABORATORY & SCIENTIFIC EQUIPMENTS - ( Tissue Float Bath )

SOM CODE : 1666/104
Model : LL26104
COMPANY : THERMOLYNE, U.S.A.

Tissue Float Bath, 2-1/2" Depth, 240V.

Low-Profile economical Float Bath.
- Controlled temperature up to 70⁰C
- Seamless 2.3 liter aluminum chamber

Product Description :

designed to thoroughly soften embedded tissue specimens without creating
wrinkles, folds or distortions.
One piece aluminium chamber is easy to clean and won't leak into electrical component areas.
2.3 liter black finished interior reduces glare, improving visibility of any remaining water on the glass slides
Chamber capacity is 2.3 liters.

Brouchure

Tissue Float Bath

SOM CODE : 330/7
Model : 50-2138
COMPANY : HARVARD, ENGLAND.

Double Bath Set 230V.

Product Description :

Temp. automatically held within 0.5°C

Dial graduated from 15° to 45°C in 5° increments

Large 11.2 L water bath capacity for stable temp. in coils and tissue vessels

Magnetic stirrer ensures uniform temp.

250 watts of heating power for fast heat-up time

Warming coils lie flat against sides of tank, leaving center free for procedures

400 ml capacity flat perfusate warming coils ensure sufficient supply of temp. controlled perfusate for lengthy assays

Detachable stem tissue vessel, for increased convenience when changing tissue vessels (tissue chamber can be removed without disturbing stem or disconnecting tubing for warmed perfusate and drainage

Specification

Heated Water Bath:

Heater Power 80 W

Temperature Control Automatic within 0.5°C

Capacity 4.7 L

Dimensions, H xW x D 15.5 x 21.5 x14 cm (6.25 x 8.5 x 5.5 in)

Tissue Vessel(s):

Quantity per Set
2

Type Supplied Fixed Stem

Perfusate Warming Coils

Type Spiral Coil

Capacity per Vessel 35ml

Thermometer Length 10cm

Brouchure

SOM CODE : D200/22
Model : 50-0322
COMPANY : HARVARD, ENGLAND.

Rod For Student Tissue Bath Set.

Product Description :

The Rod mounts in any of the three holes in the base of the student water bath .It is a standard 9.5 mm (3/8 in) diameter ,20cm (8 in) long rod with a slotted long L base. A Screw and wing nut supplied are used to secure the rod to the water bath base.

SOM CODE : D200/88
Model : 50-0488
COMPANY : HARVARD, ENGLAND.

Reservoir Holder

Product Description :

This sturdy, steel Holder is coated with white paint and has a 10.8 cm (4-1/4 in) diameter plate mounted on top of a 13 mm (1/2 in) ID, 19.7 cm (7-3/4 in) long tubular rod. The plate has three pronged spring clips to securely hold the BS4 50-0496 Constant Head 1 Liter Reservoir. Two smaller 2.5 cm (1 in) spring clips attached to one of these prongs hold the BS4 50-0587 Aeration Reservoir. The tube slips over the rod of the BS4 50-0470 Pharmacology Stand and locks in place with a knurled set screw 3.2 cm (1-1/4 in) from the bottom of the tube. A 13 mm (1/2 in) open sided connector, mounted to the base of the plate can also be used to mount the Holder to the Pharmacology Stand. Since the rod of the Pharmacology Stand is 72 cm (28 in) long, the maximum height of the Reservoir is 86 cm (34 in) and the minimum height of the Reservoir is 20 cm (8 in). Thus, the maximum distance between the Holder placed as high as possible using the set screw on the tube and as low as possible using the open sided connector on the top plate is 66 cm (26 in).

COMPANY : HARVARD, ENGLAND.

OXYGENATION TUBES,

This stainless steel oxygenation tubes are available in two sizes. The end of the tube is clinched closed and precisely ground until only fine bubbles of gas can escape from it.A wire hook at the end of the tube anchors specimens over the oxygenation tube outlet.

SOM CODE	MODEL	HOLDING STEAM LENGTH	MAIN STEAM LENGTH
D200/63	50-0363	9cm(3-1/2 in)	12.5cm(5 in)
D200/71	50-0371	5cm(2 in)	11cm(4-1/4 in)

SOM CODE : D200/27
Model : 50-2427
COMPANY : HARVARD, ENGLAND.

ROD FOR SINGLE, DOUBLE AND RESEARCH TISSUE BATH SETS.

SOM CODE : D200/94
Model : 50-2385
COMPANY : HARVARD, ENGLAND.

FLOAT PERFUSATE WARMING COIL SET FOR RESEARCH DOUBLE WATER BATH.

SOM CODE : D200/96
Model : 50-0496
COMPANY : HARVARD, ENGLAND.

Aeration Reservoir-Constant Head 1 L Reservoir.

Product Description :

This glass Aeration Reservoir attaches by means of spring clips to the main Reservoir Holder, see above. The fluid flows from the main Reservoir to the side limb of the Aeration Reservoir through flexible tubing and a plastic connector (supplied). The BS4 50- 0595 Aeration Stone with Tubing described below is placed in the Aeration Reservoir. The bottom has a piece of flexible tubing and a tapered plastic connector for attachment to the Jacketed Warming Coil. The Aeration Reservoir has an inside diameter of 2 cm (3/4 in) and is 20 cm (8 in) long. It comes supplied with two 5 cm (2 in) lengths of 7 mm ID x 10.5 mm OD tubing

Note : Please mention the product "SOM CODE" while making request for quotation and send it to dabab@somatco.com.